Ishtak vs
red clay brick
What actually changes when you switch, with the numbers and where they come from.
Typical values
Typical values
Typical market values from JK Cement fly ash brick guide (typical values). Ishtak's own tested values will be published per batch. IS 12894 sets fly ash brick classes from 3.5 to 30 N/mm², with water absorption no more than 20% up to class 12.5 and 15% above it (IS 12894:2002 requirements as summarised in the Odisha SPCB fly ash brick guideline).
Made by burning
- About 2.4 kg of clay per brick, mostly from farm fields (derived: ~600 Mt clay ÷ ~250 bn bricks a year)
- About 0.26–0.34 kg of CO₂ per brick from firing alone (derived: 66–84 Mt CO₂ ÷ ~250 bn bricks)
- Fired in kilns burning coal and biomass: 35–45 Mt of fuel a year
Made by pressing and curing
- No topsoil: the main material is ash that power plants must dispose of
- No kiln: bricks are water-cured, not fired
- The cement or lime binder does carry some carbon. We will measure Ishtak's footprint and publish it.
Sources: BEE Brick Sector Energy Mapping; Down To Earth, May 2019. Per-brick figures are our own division of the national totals and are approximate.
Where you feel the difference
Less mortar
Even sizes allow thinner joints: about 8–10 mm instead of 12–15 mm.
Less plaster
Flat faces and straight courses need a thinner plaster coat.
Less breakage
Uniform, dense bricks with sharp edges handle and stack well.
Savings depend on your mason, design and specification. Ask your engineer to check the batch report against your drawings.
Common doubts
Is a fly ash brick weaker than a red brick?
No. Typical fly ash bricks test at 7.5–10 N/mm², against 3.5–7 N/mm² for common clay bricks. Every Ishtak batch is tested and the class is shown on the report.
Will it take plaster and paint?
Yes. Wet the wall before plastering, as with any brick. The flat face usually needs a thinner coat.
Can I use it for load-bearing walls?
That depends on the design. Your structural engineer should specify the brick class; we supply to that class and show test results.
Why is it grey?
Because it is made from ash and is never fired. The colour comes from the raw materials, not from burning.
Switching a project to fly ash?
Send us the specification and quantity. We will confirm the class we can supply and share test results.